horizontal and vertical frame copper rod rolling mills/copper rod
continuous cold rolling mill
I. major information
Mechanical design uses advanced crafts and high-quality materials,
such as roller; the appearance of the machine adopts German
design,which has higher work efficiency than other similar
products；
II. Advantage of 2 high cold rolling mill
Rollers of each rolling stand are driven by separate inverter
motor. When the shape of the pass and rotating speed of each pass
stand roller are changed at the same time, each stand can operate
asynchronously. Processing rollers can change the shape of the
pass, and the gear ratio of each stand roller can be set on the
touch screen. So on the premise of meeting the stand strength,
2-roller copper rod cold rolling mill can roll different dimensions
of copper rod and also roll other materials.
III.Main Data
No. Item Data
1 Model 20mm-8mm cold rolling mil for oxygen free copper rod
2 Inlet dia 20.0mm
3 Outlet dia 8.0mm
4 Outlet rod out of roundness No more than 0.2mm
6 Rolling pass 10
7 Rolling speed Max 1.6 M/S
8 Pass schedule ellipse-round hole type system
9 total extend compression ratio 6.25
10 each pass compression ratio 1.15-1.3
11 Total installing power 200kw
IV.Main component
1. Rolling mill base 2. 2-roller motive power frame(including
reducer, Inverter motor) 3. Pay-off frame 4. coiling take-up system
5. Lubrication system 6. Emulsion system 7. Electronic control
system 8.straightening device
V.Spare parts for 20mm-8mm forming units
| No. | Name |
| 1 | rollers |
| 2 | Roll shaft |
| 3 | guide |
| 4 | Expansion sleeve |
VI.Technical process
First, check the device to see if it works normal (including that
roll wheel stands must be fill with butter per shift, the sanitary
conditions of frame and each guide and so on); after ensuring the
normal condition of the equipment and safety operation, turn on the
power supply; wait for the console touch screen to enter into the
normal working screen, then open the oil pump. After the oil pump
starts working, lubricating oil flows into the 2 high motive power
frame. for a moment, through the transparent oil return pipe the
lubricating oil can be seen to come out from the oil return hole of
the motive power frame. At this time, open the rolling mill
operation ( as well as forward and reverse); and then open the
emulsion pump, wait for emulsion to flow out from each cooling
point of the 2 high frame and roll the copper rod; the rolling
speed can not be too fast at the beginning of rolling copper rod,
but it can be speed up to normal produce when copper rod comes out
from rolling mill and penetrates into take-up machine and coil
basket. after penetration take up and looping basket ,can increase
speed. turn into normal production. When finish, turn off the
rolling mill(take-up machine),emulsion pump,oil pump,main power in
order.
55mm, 35mm, 25mm, 20mm, 17mm, 16mm, 14.4mm, 12.5mm, 8mm
20mm,18mm, 17mm, 8mm, 6mm, 5mm, 4mm, 3mm
Dear friends,
welcome to contact with us!
